Fully Automatic Mask Making Machine 1+1

1. All adjustments must have a reference, otherwise it cannot be debugged later.

2. On the unwinding rack, pay attention to the up and down position of the bridge of the nose, with the convex direction facing upward, and there is a wire guide wheel on the bridge of the nose. This part is currently missing from many drawings.

3. The tension is adjusted properly, and the feeding position of the material belt is symmetrical. It is best to have a scale for easy adjustment.

4. Replace the folding mechanism with two or three tapered stepped shafts, and the upper and lower two installations should be careful not to install the opposite directions, and the adjustment heights of both sides must be the same.

5. After the folding mechanism, there are two upper and lower shaping rollers. At present, many drawings only have one. Two mounting plates need to be redone, and a roller (component one) is added to the top. There is a roller (component two) behind, and the distance between component one and two is best adjustable. Several rows of screw holes can be drilled on the platen to facilitate the adjustment of the distance.

6. The long ribs of the upper nose bridge mechanism need to be chamfered. At present, many drawings do not have chamfers. This part needs to be redone and only needs to be modified.

7. There is only one side wall and one edge of the rolling knife on many drawings, and some edges of the rolling knife need to be redone.

8. There are many refueling skills, if you are proficient, you can change it in a minute or two. In fact, there are no big problems with all the drawings in general, and a mechanical engineer can handle it.