SUNY GROUP

scrap copper cable cutting machine

0000-00-00 00:00:00

The recycling of waste cables is beneficial to the environment and to the enterprise without any harm. In the past, manual recycling was not only a heavy workload and low efficiency, and it could not achieve fast and effective recovery of cables. This is the case with the waste cable stripping machine. Special machinery for the aspect.

Cable Stripping Machine

2. Working principle of waste cable stripping machine

Before separating the surface of the waste cable from the inner core for recycling, the street of the cable should be cut off to ensure the long-lasting durability of the blade, and then start feeding. The surface of the cable will pass through the blade on the machine and be cut by the surface, and then the conveyor belt The cut waste cable is sent to the drum, through the strong squeezing force of the drum, the inner core and the surface layer begin to separate, and then the personnel start to classify and tie the surface layer and the inner core. This is the complete working principle of the waste cable stripping machine .

3. Precautions during the recycling process

1. Note that the blade should not be too sharp, so as not to damage the inner core, and pay attention to the location of the blade according to different cables.

2. Pay attention to check whether the position is wrong when feeding.

3. Pay attention to whether the pressure of the springs on both sides is too tight, too tight will cause the cable to fail to pass.

Leave Message

Thank you for your interest in suny group. If you want to learn more about our products,Contact us now and get information and quotes for free!E-mail:sunymachine@gmail.com | Whatsapp:+8613674945231

Name: *
Country:
Email: *
Tel/Whatsapp:
Raw Material:
Capacity:
Message: *