How to debug the copper wire recycling machine?

The copper wire recycling machine is now an indispensable machine for recycling waste wires. The copper wire recycling machine can be used to efficiently shred and recycle waste wires and cables. The copper recovery rate can reach 99%. At the same time, because of the effect of the copper wire recycling machine If you want to achieve the best, you need to carry out continuous debugging, because each customer's waste wire materials are different, and only after careful debugging by workers can you achieve the desired effect.

1. During debugging, the feeding amount should be controlled at about 30% of the output of the machine, so as to avoid the accumulation of materials at the tail of the machine caused by the untimely adjustment of the single machine. The initial value of the speed frequency of the inverter of the down blower is adjusted to between 35-40Hz, and the value increases or decreases according to the sorting situation.

2. The initial value of the speed frequency of the frequency converter of the vibration sorting motor is adjusted to 28-35Hz, and the value is increased or decreased according to the sorting situation.

3. The initial value of the air volume of the front and rear dust removal and exhaust air is adjusted to the middle position of the pointer in the adjustment range, and the value increases or decreases according to the discharge situation.

4. After the equipment is successfully debugged, the trial production can be started. In the first trial production, the feeding amount should be controlled at about 50% - 60% of the output of the machine. After continuous production for 3-5 hours, the output will be gradually increased. - The output of 10% increase in 5 hours shall prevail, and it must not be loaded at full load at the beginning, because each machine needs a running-in process.

The above is the relevant introduction about the debugging of copper wire recycling machine. SUNY GROUP has rich experience in the production of copper wire recycling machine. When each equipment leaves the factory, relevant debugging will be carried out until the customer is satisfied. At present, the copper wire recycling machine manufactured has been sold to India, Europe and the United States and other countries and regions, and has been well received and trusted by customers.